Installation Instructions

v4-0919

To install the arms of the walker, attach the Inner Arms to the Tree

with the ⅞" x 5" bolts provided. Raise the Inner Arm and bolt it to

the Support Strap with the ⅝" x 1½" bolts.

⅞

" x 5" Bolts used

to attach inner arm to

Horse Walker tree.

⅝" x 1½"

Bolts used

to attach support strap

from tree to inner arm.

Note: Do not install the nuts for the 7/8" x 5" bolts until all arms have been

installed. This will allow bolts to slide out to allow the next arm bolt

to be installed. Once all arms have been installed, then install and

tightened all nuts.

To attach Tree, use a chain or strap

to attach to the lifting eye at the top of

the walker Tree. Pick up the Tree and

slide it over the main shaft.

When the Tree is all the way down,

rotate to make sure it slides down and

locks in place on the main shaft.

USE CAUTION NOT TO

DAMAGE BRUSH ASSEMBLY

AS SHOWN IN PREVIOUS STEP.

BRUSH ASSEMBLY WILL CONTACT

BASE OF TREE.

To set the Base Assembly to the Concrete Pad, attach a chain

or strap to the lifting eyes on each side at the top of the Walker

Base and raise the walker with a forklift or front end loader.

NOTE: The Base weighs approximately 1200 lb. Be sure the

equipment used for lifting the Base is able to handle this

working weight.

USE CAUTION TO PREVENT

STRAP OR CHAIN DAMAGING

BRUSH ASSEMBLY

FOR HANGING PANELS

(See picture at right).

Make sure the walker is level,

put anchor bolt nuts on

and tighten.

REMINDER: BE SURE TO

INSTALL BREATHER

AS SHOWN ON