Installation Instructions

v4-0919
04
½"
Shackle
Top Cable Loop
NOTE:
THESE STEPS
WILL BE
EASIER WITH
ASSISTANCE
OF ANOTHER
PERSON.
Continue to attach top cables until all four arms are complete.
Tighten all of the Top Cables until there is a slight bow in the arm.
6. Using the procedure in Step 5, attach all four
Inner Arms to the Tree.
Slide the end of the Outer Arm over the end of
the Inner Arm until the two pieces butt together.
7. Locate the four ⅝" Turnbuckles, four 184 ½" (1/2") Top Cables and four ½" Shackles.
Attach the four top cables to the end of the outer arm with the ½" shackle.
Unscrew the four turnbuckles to the full extension.
Attach one end of the turnbuckle to the cable. Then, bolt the other end of the turnbuckle to the loop at the top of the tree.
This will require assistance from someone, or a lifting device, to raise the outer end of the arm to allow enough slack to
bolt the turnbuckle to the tree.
8. Unscrew the four ⅝" Turnbuckles to the full extension.
Lay out the two 138¾" (5/16") Inner Turnbuckle Cables and
attach one end of the Turnbuckle to one end of each cable loop
as seen below.
Attach a ⅜" Quick Link to the other end.
When installing
Outer Arms, be sure
mounting bracket
for Hanging Panel
faces down.