Installation Instructions

v5-0919
TURNBUCKLE
TURNBUCKLE
TURNBUCKLE
05
12. Attach the three 270" (") outer cables, in the same
manner as the inner cables, at the ends of the arms
by using the quick links to attach the cable ends to the
loops on the side of the arm.
13. As before, attach the three 244" (") cables at
one end with a quick link, and at the other end
with a ½" turnbuckle. Position the turnbuckle
opposite to the turnbuckle of the inner cables.
Tighten the turnbuckle until all of the slack is
out of all six cables. After all of the cables are
in place, the top turnbuckles may need to be
tightened again.
3/8" QUICKLINKS
10. Attach the three 111¾" (") inner cables to the
loops at the center of the arms by using the "
quick links provided. Alternate these cables with
the turnbuckle cables in the next step.
11. Attach the three 88” (") inner cables at one end with
quick link and at the other end with a ½" turnbuckle.
NOTE: DO NOT FULLY TIGHTEN ANY TURNBUCKLES UNTIL ALL CABLES ARE ATTACHED!
NOTE: WHEN TIGHTENING CABLES, BE SURE TO TIGHTEN TURNBUCKLES
UNIFORMLY TO PREVENT WARPING OR BOWING OF THE ARMS.
CONNECT INNER AND OUTER TURNBUCKLES
ON OPPOSITE SIDES