Installation Instructions

v5-0919
Hanging Panel & Stabilizer Assembly
07
Allow 14'
minimum height
clearance from
Concrete Base
to any overhead
structure to
provide space
to assemble or
remove Tree
from Base
assembly.
Approximately 10'
overall height
1. After all cables are tightened, bolt the panel straps to the mounting ears on the arms. The bolts
are assembled on the brackets of the Panel Straps. Remove the bolts from the end of the
brackets and install in the mounting ears on the arm. The short Panel Strap will go into the inner
mounting ear and the long Panel Strap will go into the outer mounting ear. (See examples pg. 08)
There are more holes in the outer strap then there are in the inner strap.
NOTE: Install the outer strap with the
“WARNING” label facing outward.
2. Install the Hanging Panel onto the Panel Straps you just assembled. With
the help of another person, lift the panel where the bottom of the panel is
16”- 20” o󰀨 the ground. The panel must hang level. (See detail at bottom of
pg. 09-10). Use four ½” bolts & locknuts to attach. Be sure to note which
holes you used and bolt the remaining panels in the same position.
3. Allow a few holes above the Hanging Panel and attach the Stabilizer Bar
between the Panel Straps using four ½” bolts & locknuts.
5. Run the panel charger wire along the arm securing it to the
arm with the zip ties provided. Crimp one of the provided ring
terminals on the inner end of the
wire and attach to the nylatron
ring located on the bottom side
of the Horse Walker Tree using
¼" x ½" bolts. (See pg. 11)
Crimp another ring terminal
on the other end of the
wire and connect it to the
Panel Strap using the
¼" x ¾" bolt, washer and nut.
See Page 11 for detail of Electrical Connections.
Panel Mounting
Brackets
4. After all panels are installed, you will need to adjust the top
cables to level the panels completely. Adjust turnbuckles on
every arm until they are exactly the same.
Zip
Tie
Ring
Terminal