Installation Instructions

v5-0919

Locate the rst curved inner panel and attach it to the 4' panel using the latching pins. Be sure you have inserted the

Anchor Stake Clip, and that it faces towards the center of the ring. As you are installing the panels, manually turn

the Horse Walker Hanging panel that is attached to the arm, rotating around to each panel to make sure you have

the proper clearance.

After clearance is achieved, drive Stake through hole on Anchor

Stake Clip, half-way into ground as you work your way around.

Attach another curved panel as before,

achieving proper clearance, and driving a

stake half-way to hold the panel in place.

Continue around Inner Ring to meet the

Latching pins on the Bow Gate.

Again, manually turn the Horse Walker

Hanging panel around to each panel

to make sure you have the proper

clearance around the entire inner ring.

Adjust as necessary.

Round Pen Assembly

Before Beginning:

Determine location of Inner Bow Gate, and at 16'-10" from center. R

otate the Horse Walker Tree around until there is a

hanging panel in-line with the hinge side of Bow Gate. Be sure to install an Anchor Stake Clip in the bottom of each panel

before locating and attaching panel. As you install the gate and curved panels, adjust the Round Pen panels around until

there is approx. 4"- 6" of clearance between the hanging panel and curved panel on the Inner Ring and approx. 6"- 7" on Outer

Ring, as shown on page 9-10 under Critical Dimensions. After the Bow Gate and 4' panel is in place, drive one Stake half-way

into the ground, (Partially drive stakes to hold panels in place - you may have to remove previously driven stakes for

adjustments) going through the holes of the Anchor Stake Clips. Repeat as you work your way around with Curved Panels

until you work all the way around to the Bow Gate.

NOTE: Do not drive stakes completely into the ground until all panels are assembled and located to allow for adjustment if needed.

Inner Ring - First

Locate position for the inner Bow Gate. Attach the Bow Gate to the 4' panel using the

connector pins. Be sure the Anchor Stake Clips and the latching pins face toward the

center of the Horse Walker as shown in DETAIL A. Drive (1) Anchor Stake, through

hole on in the clip, half-way into ground

DETAIL A

LATCHING PINS

ANCHOR

STAKE CLIP

ANCHOR

STAKE CLIP

ANCHOR STAKE CLIP

Outside View

Inside View

Outside View