Installation Instructions

v5-0919

Programming an Additional or Replacement Remote Control

for the Automatic Horse Walker

Read These Instructions Completely Before Beginning

Note: The circuit board allows for 4 seconds between pressing the Programming Button to activate the

function light, and pressing the corresponding button on the remote.

Tools required: Flat-head screwdriver and Phillips screwdriver.

Using a at-head screw driver, turn the two latch screws counter-clockwise to open the

Control Panel Box. Refer to Fig.1 for circuit board Box location.

Touch Screen

Control Panel

Push Button

Control Panel

Fig. 1

Circuit Board Box with

Cover Plate Removed.

Replace cover and secure

after programming remote.

The Remote Control for the Horse Walker comes

pre-programmed from the factory.

Programming is only necessary if additional, or replacement Remote Control is purchased.

Circuit Board Box (Fig. 1)

Using a Phillips screwdriver, remove the cover from the Circuit Board Box.

Turn on the power to the Control Panel. Top left Green Light on Circuit Board will be on

when power to Control Panel is ON.

See next page for Programming the Remote Control

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.