Installation Instructions

v5-0919
REMEMBER: The circuit board allows for 4 seconds between pressing the Red Programming Button to activate
the LED function light, and pressing the corresponding button on the remote.
Press Red
Programming Button
This Function
Light
will appear
(Red LED)
Then Press
this button on
the Remote
1
Press and hold the red
Programming Button until
the 1st function light
(Red LED) comes on.
Immediately press the “O/1”
button on the Remote.
— the red LED light will blink.
This Function
Light
will appear
(Red LED)
Then Press
this button on
the Remote
Press the red Programming
Button again,the 2nd function
light (Red LED) will appear.
Immediately press the “Faster”
button on the Remote.
—the red LED light will blink.
Press Red
Programming Button
2
This Function
Light
will appear
(Red LED)
Then Press
this button on
the Remote
Press the red Programming
Button again, the 3rd function
light (Red LED) will appear.
Immediately press the “Slower”
button on the Remote.
— the red LED light will blink.
Press Red
Programming Button
3
This Function
Light
will appear
(Green LED)
Then Press
this button on
the Remote
Press the red Programming
Button again, the 4th function
light (Green LED) will appear.
Immediately press the “Fwd/
Rev” button on the Remote.
— the green LED light will blink.
Press Red
Programming Button
4
Your replacement Remote is now programmed to operate.
Wait for the four function lights to shut off before powering off the Control Box.
Replace the cover on the Circuit Board Box and close the Control Panel Box. You may now begin using your Priefert Horse Walker.
14