Installation Instructions

v5-0919
Section 1: MANUAL CONTROL Tab:
This tab displays the options for Manual Operation.
The Time and Speed of operation must be selected rst
• Time can be set by touching 15 minutes , 30 minutes or
60 minutes . Touching button again will increase the time
to a maximum of 60 minutes. Time selected will appear in the
vertical indicator bar on the right, and Time Remaining will
count down when Walker is started.
• Speed can be set by touching the up or down arrow buttons.
The up arrow increases speed, down arrow
decreases
speed. This will show as miles per hour (MPH) to a maximum
of 16.0 MPH. Tapping the speed indicating window will allow
manual entry of the desired speed.
• Clockwise or Counter-Clockwise operation can be selected
by touching the Direction Button
. Direction can be changed
anytime during operation, Walker will ramp-down, stop, then
reverse and ramp-up again to the selected speed.
• Once the Time and Speed has been selected, touching the
green start button
will begin operation, and walker will
ramp-up to the selected speed for the selected time.
Walker can be Paused or Stopped
any time during
operation, but the countdown time remains when paused.
Pressing Stop will Reset time to zero.
Options for Remote Control Operation.
Walker Operation Using the Remote Control Diers
from Manual Operation
• If no time has been selected in Manual Operation, Time
will default to 15 minutes when "0/1" button is pressed for
3 seconds. Walker will ramp-up to the previously set MPH.
• Pressing "Faster" will increase Walker speed,
pressing "Slower" will decrease Walker speed.
• Change direction by pressing "Fwd/Rev".
NOTE: When Walker is operating, press and hold "0/1" for
three(3) seconds to pause Walker. Once paused, press and
hold the "01" button for three(3) seconds to restart.
16
SET TIME
SET SPEED
SELECT DIRECTION
TOUCH START
START / STOP INCREASE SPEED
DECREASE SPEED
CHANGE
DIRECTION
REMOTE CONTROL FUNCTIONS