Installation Instructions

v5-0919
Optional Spray Kit Installation
Be sure to have a licensed plumber facilitate connections of the water supply. Stub-up waterline where the Water Supply
Tee will be located to enable connection. Priefert recommends 3/4" Sch40 PVC, sand sheathed, buried below freeze level.
After completing the assembly of the walker and round pen, determine a location closest to the water supply.
Preferably, the water supply will be installed during the concrete pad preparation. This allows waterline to be run
at the same time as electrical conduit (pg. 1).
If necessary, a water supply may need to be brought to the location of the Horse Walker. If this is the case, water supply
will have to be buried beneath the walker panels and dirt base.
1. Prepare The Nozzles
Unpack and identify all parts before beginning.
Assemble twelve (12) Spray Nozzles (See Diagram 1).
Locate Poly Tube and cut twelve (12) sections, 2" long.
Insert assembled Spray Nozzles fully into one end of each.
Locate ten (10) PVC Tee ttings and insert into the other end of ten (10) of the tubes on the Spray Nozzles.
Locate two (2) PVC 90˚ ttings, and insert them into the remaining two (2) Spray Nozzle tubes.
Locate the one (1) remaining Tee tting. This will be used for the connection to the water supply.
Spray Kit installs on the Inner Ring,
along the rail at the top of the solid
section of each panel, Nozzles facing
outward. (See Diagram 2)
2. Assemble The Tubing
Begin by determining where the closest panel
connection is to the water supply. This will be
the starting point to run tubing and nozzles from.
Preferably, this will be opposite of the Bow Gate
or generally centered between the two ends of
the nished tubing assembly (See Diagram 2).
Connect the remaining Tee tting to one end of
the Tubing. This Tee will connect to the main
water supply from the Anti-Siphon valve.
Attach to the rail at the top of the solid section
of the panel with supplied, self-tapping, sheet
metal screw and Tubing Strap (See Diagram 3).
Use three to ve Tubing Straps per panel to hold Tubing securely. Some adjustment may be necessary after completing
assembly. Add Tubing Straps as needed.
Note: Temporary tment can be done with plastic zip-ties.
21
Diagram 1
Inner Ring
Bow Gate
4’ Panel
Inner Ring
Panels
Nozzle
+ Tee
Nozzle
+ Tee
Nozzle
+ Tee
Nozzle
+ Tee
Nozzle
+ Tee
Nozzle
+ Tee
Nozzle
+ Tee
Nozzle
+ Tee
Nozzle
+ Tee
Nozzle
+ Tee
Nozzle
+ 90˚
Nozzle
+ 90˚
Water Supply
Tee
Outer Ring
Panels
Poly Tubing
Poly Tubing
STANDARD SPRAY KIT
NOZZLE & CONNECTOR
LOCATION
USE THIS DIAGRAM FOR REFERENCE ONLY
NOT TO SCALE
BEGIN ASSEMBLY HERE
Diagram 2