Installation Instructions

v5-0919

Concrete pad should follow the above specications.

2. Walker Base Assembly will sit on an anchor bolt pattern of 18" x 22". The 18" side will be the

front side with the door. Overall diameter of walker to the end of the arms is approx. 52' - (26' Radius).

When placing the walker, keep the end of the arms 10' to 12' feet from any obstruction.

IMPORTANT: IF factory provided Anchor Bolt Jig is NOT used in installation, use INDUSTRIAL GRADE 3/4" anchor bolts.

NOTE:

Top of pad should

be ush with ground or 1" above.

60"

We Strongly Recommend using the included

Structural Anchor Bolt Jig

Concrete Pad Preparation

Panel Walker

and Lead Walker

Require

240 VAC 30 Amps.

See Page 11

for Electrical

Connections

HORSE WALKER CONCRETE PAD DIMENSIONS

Not to Scale

Approx. 4” of conduit above pad.

ADDITIONAL NOTE: If Optional Spray Kit is to be installed, waterline should be buried during this step of the

installation process. Priefert recommends Sch40 PVC buried below the freeze level for your location. Determine

the water supply location for the Spray Kit, and stub up and cap for that installation. (See Page 21)

IMPORTANT: Be sure to select an area that is large enough to accommodate the Horse Walker Outer Ring with

sucient clearance all around. Area should also be level, and if possible, slightly higher than surrounding terrain

to allow drainage, but not excessive runo. Avoid low-level areas which could lead to ponding, puddles and

depositing of sediments. Level grading surface location prior to installation will produce the best results.