Installation Instructions

v5-0919

Repeat to attach all six inner arms to the tree.

Slide the end of the outer arm over the end of the inner

arm until the two pieces butt together.

4 Horse Walker shown

"

Shackle

Top Cable Loop

Attach the six 241½" (½") top cables to the end of the outer arm with the ⅝" shackle, and through the eyelet of the

triangular cable guide on top of the outer arm.

Unscrew the six ⅝" turnbuckles to the full extension.

Attach one end of the turnbuckle to the cable. Then, bolt

the other end of the turnbuckle to the loop at the top of the

tree. This will require assistance from someone, or a lifting

device, to raise the outer end of the arm to allow enough

slack to bolt the turnbuckle to the tree.

Tighten turnbuckle until cable aligns in the center of the

cable guide eyelet (see inset).

Continue to attach top cables until all six arms are complete.

Tighten each turnbuckle until the cable aligns in the center of the cable guide eyelet as shown in the inset above.

Locate the six ½" turnbuckles, three 88⅛" Inner Turnbuckle Cables and 244" Outer turnbuckle cables.

Unscrew the six ½" turnbuckles to the full extension.

Lay out all the cables and attach one end of the turnbuckle to one end of each cable.

*WHEN INSTALLING OUTER ARMS, BE SURE TRIANGULAR CABLE GUIDES ARE POINTING UP

INSET

Cable alignment with eyelet

of triangular cable guide

Cable centered

in eyelet

Cable Guide Pointing Up*