Installation Instructions

07&7㤧䈣䈪᱄ҜPLQWKRX](
60 x 90mm
J䬒ᶵ㓮഑㢨䶘দ࡭ሯᣎ

୆ᮽᖟ
䇴䇗
420 x 90mm
Touch controls
1 tap
QJɛWNLMYJFWGZI
2 tap
QJɛWNLMYJFWGZI
QTSLUWJXX
QJɛWNLMYJFWGZI
MTQIXJH
QJɛWNLMYJFWGZI
&SX\JW*SIHFQQ
,FRNSLRTIJ
3TWRFQRTIJ
'FXXGTTXYRTIJ
9ZWSTSTɐ
[TNHJFXXNXYFSY
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
3
FCC ID:2AQK8-D59