Instruction manual

HSMR
8
1
5
2
3
4
6
7
Fast Select: Provide the fast setup be tween inputs and outputs
of the matrix. “Channel 1” makes all outputs see input-1, same
for the remaining buttons.
Output Channel Setup: Click on this button, a quick selection
table of inputs will show up. Users can therefore easily select
the input video for each output.
7
8
1. +5V DC: Spare power jack for over 60m transmission when the RX
may need external power to work*.
2. TMDS: Plug in the CAT5 connected to the respective TMDS port
on the HSW44C
3. DDC: Plug in the CAT5 connected to the respective DDC port on
the HSW44C
4. INPUT CHANNEL: Display the current showing HDMI source
channel
5. INPUT SELECT: Push button for switching input source channel in
sequential order
6. Signal Level 0-7: Adjust the 8-level equalization control for HDMI
signals. 0 = strongest to 7 = weakest. It is recommended to switch
from 7 to 0 to find the optimal visual experience.
7. HDMI Output: Connect to HDTV with a HDMI cable
8. IR RECEIVER: Plug in IR receiver
The HSMR has been tested extensively and found that it doesn’t
require external power supply. If in rare situation you find it
cannot work with the HSW44C, please use any +5V power
adapter to plug in the power jack and see if it can work. If not,
please contact our technical support for further service.