Instruction manual

DIP SWITCH
Scan: Choose COM port number and Device ID for scan. Then
tick “Scan Device ID”and press “Scan” button to know which
COM port is connected based on this Device ID.
Linkage: Indicate the connection status.
Open: Open the COM port after scan to establish the connection
between PC and the matrix.
Close: Release the COM port after scan.
Mapping: Click on this button, a quick selection table of inputs will
show up. Users can therefore easily select the output video for each
input by pressing “Output” button.
2
3
4
5
6
SW1-SW4 for EDID/Audio
Note:
1. If the HDTV shows video but without audio, please try to
set audio mode to stereo.
2. Factory default setting of [SW1]-[SW4] is pin 1 at OFF ( ) &
pin 2 at OFF ( ) for 1080p with surround sound audio.
3. If you encounter any unsolved audio/video output
problem during system installation, please turn any
[SW1]-[SW4] to pin 1 at OFF ( ) & pin 2 at ON ( ) for
safe mode to enforce the most compatible 720p stereo
output for system check. However, the safe mode cannot
be initiated if your HDMI source is set to enforce 1080p output.
In this case, please reconfigure your HDMI source to all
resolution output for troubleshooting.
4. Bypass means the matrix will maintain playing the original
format of HDMI signals in video and perhaps audio. By setting
at this mode, the users may encounter compatibility issue
among different kinds of HDMI sources and displays. If you
cannot get the audio and/or video output normally at the
system installation, please change the DIP switch setting to
default mode or even safe mode to verify the functionality of
the device.
5. To learn the EDID of HDMI display for respective HDMI source
devices, please see the [EDID Learning] section in the next
page for more detail information.
DIP Switch Position
Video Audio Description
Pin 1 Pin 2
OFF [ ] OFF [ ]
Up to
1080p
Surround
1
Default Mode
2
– Up to 1080p video & surround
sound audio output up to 7.1ch DTS-HD & Dolby
TrueHD
OFF [ ] ON [ ]
Up to
1080p
Stereo
Safe Mode
3
– Enforce the system output at 1080p
video and stereo audio for basic compatibility
among HDTVs
ON [ ] OFF [ ] Bypass
4
Bypass
4
EDID Learning Mode
5
– for learning EDID from the
display while playing any received HDMI audio
format
ON [ ] ON [ ] Bypass Stereo
EDID Learning & Stereo Mode
5
– for learning EDID
from the display while enforcing stereo output if
any HDTV cannot play surround sound normally