Instructions / Assembly

7 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Installation (continued)
3
Marking the mounting
locations
4
Drilling mounting holes in
concrete/brick wall
□ Use the holes in the wall plate (A) as a template
to mark the mounting locations for attaching the
wall plate (A) to the wall. Use a level to ensure
that the markings are even.
If you are installing the mounting system into wood
studs, proceed to step 5.
CAUTION: Avoid drilling near electrical
wiring and water pipes. The mounting system
must be attached to a weight bearing wall.
Failure to observe all safety precautions can
result in serious physical injury and/or
property damage. Consult a professional
installer or call customer service if you have
any questions.
CAUTION: Do not drill into mortar
between bricks or into loose concrete.
CAUTION: Never drill into hollow brick.
□ Use a ¼ in. (6 mm) masonry drill bit to slowly
drill 3 in. (76 mm) pilot holes. Then use a 3/8
in. (10 mm) masonry drill bit to expand the
pilot holes.
□ Insert anchors (AA) into the holes. Use a
hammer if necessary. Ensure the anchors
are completely flush to the concrete surface
even if covered by a layer of joint compound
or other material.
A
AA