Datasheet

11
12
G H
Stop pushing on the plunger once the water starts to come out from the chamber of the reversible fuel cell
(C). Disconnect the syringe (J) from the nozzle tube and attach the red pin to the tube. Let the reversible
fuel cell settle for 3 minutes.
Place the water container base (H) with the Horizon logo facing towards you.
Insert the hydrogen outer storage containers (D) into one of the round slots located on the water
container base (H) (see D).
Insert the oxygen outer storage containers (E) into the other round slot on the same base (see E).
Insert the two inner containers (F) into the hydrogen and oxygen outer containers (D & E) (see E & F).
Note: There are two openings at the bottom of each of the inner containers (F). These openings allow
for gas to escape the inner containers (F) into the outer containers to limit the amount of gas stored.
Make sure these openings are not blocked by the raised plastic frame holding the inner containers (F).
Push on the top of the inner containers (F) to be sure they fit firmly onto the plastic rim located at the
bottom of the outer storage containers.
D E F
Use scissors to cut out one 16cm long tube.
Connect one end of this tube to the nozzle of the inner hydrogen container (see G).
Connect the other end of this tube to the lower nozzle on the hydrogen side of the reversible fuel cell
(see H).