Datasheet

PM-14

INSTALLATION. Install this module into a metallic enclosure correctly ventilated.

Connect the ground of the circuit to the chassis of the enclosure and keep enough distance with others modules

OPERATING MODE. Once the installation done, you could activate the Vox Control module.

Eacht ime you supply the module, the relay will be momentary connected. This activation could not be eliminated

becauseit is necessary for the modules tarting. After activating the module, each time the microphone will receive (catch) a

signal it connect the output,maintain this state during the signal reception. If you wish to adjust the module's sensitivity to

allow the PM-14 module be activated from a determined signal level, you have to adjust it using the potentiometer

indicated on the General Wiring Map.

IMPORTANT : The union cable between microphone and circuit could be cut, extended, or changed. If you don't

respect this point, the module could be damaged and the warranty will be automatically cancelled.

GENERAL WIRING MAP