Service manual

CEBORA S.p.A. 18
5.3
- Panel board (26) code 5.602.183.
5.3.1 - Topographical drawing.
5.3.2 - Connector table.
Connector Terminals Function
CN1 1 “+” input for torch potentiometer.
CN1 2 torch potentiometer cursor output.
CN1 3 “-“ input for torch potentiometer.
CN1 4 “START” signal output.
CN1 5 “DOWN” signal output.
CN1 6 “UP” signal output.
CN1 7 NU.
CN1 8 “shared” input for signals from outside.
CN2 1 +5 Vdc input for panel board (26) supply.
CN2 2 0 Vdc input for panel board (26) supply.
CN2 3-4-5-6-7-8 leds driving inputs.
CN2 9 (A) button signal output.
CN2 10 (H) potentiometer signal output (current adjust).
CN2 11 (M) potentiometer signal output (slope adjust).
CN2 12 (L) potentiometer signal output (post-gas adjust).
CNP 1 “START” signal input.
CNP 2 “+” output for torch potentiometer.
CNP 3 NU.
CNP 4 “DOWN” signal input.
CNP 5 NU.
CNP 6 NU.
CNP 7 “-“ output for torch potentiometer.
CNP 8 “UP” signal input.
CNP 9 “shared” output for signals from outside.
CNP 10 torch potentiometer cursor input.
3.302.212 12/01/06