User's Manual

Page 21 of 21
Last GPRS service 上次 GPRS 业务
Bytes transmitted during the last GPRS service.
Call timers 累计时间
 MOC time: you can check the total time spent on dialed calls.
 MTC time: you can check the total time spent on received calls.
 Clear timers: you can reset the timer.
Displaying a call cost 显示话费
The “Display” feature can be turned on or off. If it is activated, both call time and cost are
displayed during a call. The default setting is off. You need PIN2 code provided by your
service provider to activate this feature.
Accumulative cost 累计通话费用
This is feature is only available if supported by your SIM card. It allows you to access the
following operations and information:
 Show cost: to display the accumulative cost of all dialed and received calls since the
last time you reset the cost meters;
 Reset cost: to reset the cost meter to zero (PIN2 code required);
 Balance: remaining call cost;
 Show limit: the upper limit of call cost that that has been preset;
 Clear limit: to cancel the upper limit of call cost that has been preset (PIN2 code
required); and
 Set limit: to set an upper limit of call cost (PIN2 code required).
If the upper limit of call cost is exceeded, “Call cleared” is displayed. In this case, you cannot
place any call that is chargeable.
Charge rate 个人费率
You can check and change the charge rate. The charge rate is stored in your SIM card in
decimal form.
 Display rate: to display the current charge rate.
 Reset rate: to reset the charge rate upon confirmation. PIN2 code required.
 Set rate: to change the charge rate. PIN2 code required.
3.2 Quick settings 环境设置
Through quick setting, you can take advantage of a preset parameter set under certain
circumstances. The current setting is marked with an icon on the right.
This feature allows you to customize your phone for use in five typical surroundings, that is,
normal, silent, outdoor, car and meeting. The preset parameters can be activated through
easy operation.