Troubleshooting guide

PROGRAMMING INSTRUCTIONS

To access SERVICE MODE – Press simultaneously

Center of CECILWARE LOGO and Center of FAST FLOW LOGO

To access PROGRAM MODE – Press simultaneously

RINSE and STOP

To decrease or increase parameter

LCD WINDOW

CLEAR

PUSH

TECHNOLOGY INSIDE

MODES OF OPERATION

1. Initializing Mode – This mode is only active during the first few seconds after a “power-on” or system reset. The main

function of this mode is to configure the system using the previously saved operating parameters.

2. Normal Mode – This mode becomes active immediately after Initializing Mode has completed its tasks. The main

functions of this mode are to monitor and report system status and control dispensing.

3. Rinse Mode – This mode becomes active when the Rinse key is depressed with any dispense key. The main function of

this mode is to allow the operator to initiate an individual Rinse for all mixing chambers.

4. Program Mode – This mode becomes active when the Rinse and the Stop keys are simultaneously depressed for more

than 1.5 seconds while in Normal Mode. The main function of this mode is to provide limited access to frequently used

system parameters. Pressing the Rinse and the Stop keys again will return the touchpad to normal mode.

5. Service Mode – This mode becomes active when the hidden keys under the “Cecilware Logo” and the “Fast Flow

Logo” are simultaneously depressed for more than 1.5 seconds while in Normal Mode. The main function of this mode is

to allow access to all system parameters that can be modified. Pressing the “Cecilware Logo” and the “Fast Flow Logo”

again will return the touchpad to normal mode.