Specification

24 [e-mail]
Step 10: Attach TNR2 Slide Exit to Exit Elbow Assembly
A: Insert ange of Exit Elbow Assembly (slide elbow) into the slots on TNR3 Short Exit. (g. 10.1)
B: Rotate Slide Exit and use Quadrex Driver as a guide pin so the holes are aligned and attach with 5 (PB1) 1/4
x 3/4” Pan Bolts (with lock nuts) starting with the bottom middle hole and working up each side. (g. 10.2 and
10.3)
C: At this point make sure all the slide bolts are tight. Use a 7/16” open end wrench to hold nut and then
tighten bolt with Quadrex Driver on Clamp Rings.
Hardware
5 x 1/4 x 3/4” Pan Bolt
(1/4” lock nut)
PB1
Other Parts
Exit Elbow
Assembly
Bottom of Slide Views
TNR3
Short Exit
Lock
Nut
PB1
Lock
Nut
Start with
this bolt
Slot of TNR3
Short Exit
PB1
PB1
1 x TNR3 Short Exit
Fig. 10.1
Fig. 10.2
Fig. 10.3