Service manual

Issue 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

3.0 PROGRAMMING

NOTE: It is recommended that you ground yourself to prevent ESD

damage to the PCB(s).

3.1 Connect the telephone to a working telephone line or a DTMF test set.

3.2 Locate the pair of plastic mini-jumpers along the edge of the PC board.

Move them to the “ON” or inner most position as depicted in the diagram,

on the last page of this manual.

3.3 If the phone does not have a DTMF keypad mounted on the back of the

telephone panel, but rather one has been provided separately, connect the

keypad at this time. In order to connect a separate keypad, locate the

multicolor ribbon cable extending from the printed circuit board with a

white connector on the loose end. Connect that white connector to the

white connector on the keypad. The connectors will only mate one way.

3.4 Press the “CALL” button and wait for dial tone before entering

programming digits.

3.5 Utilizing the keypad, enter # 9 7 # 1 8 # # 1 9 # # 0 1 #, which will clear

all user programmable memory.

NOTE: Once the # key has been entered, you may hear a fast busy tone,

an operator recording, or other Central Office signals. Please disregard

these sounds and continue programming, as they will have no effect on the

programming.

3.6 If a PBX access code or number must be dialed, enter # 1 8 followed by

the required code or number. When the phone is in operation and the

CALL button is pressed, this PBX code or number will automatically dial

first. Please note that Digit 8 in section 3.9 must also be set to “1” for

this feature to be activated. The number may be up to eleven (11) digits in

length. If this feature is not desired, continue to section 3.7.

Example: Enter # 1 8 9. This will program the phone to automatically

Dial a “9” when the CALL button is pressed.

3.7 In order to program the auto-dial number, enter # 1 9 followed by the

desired auto dial number. The number may be up to eleven (11) digits

in length.

Example: Enter # 1 9 5 5 5 1 2 1 2. This will program the phone to

automatically dial the number 555-1212, when the CALL button is

pressed.