Service manual

Issue 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
6
PROGRAMMING CONTINUED…
3.8 If a second auto-dial number is desired, enter # 0 1 followed by the
desired second auto-dial number. This number will automatically dial
out after the selected number of unanswered rings from the first auto-dial
number. The number of rings is selected under Digit 6 in programming
section 3.9. The second auto-dial number may be up to eleven (11) digits
in length. If this is not a desired feature, proceed to section 3.9.
Example: Enter # 0 1 7 7 7 1 3 1 3. During programming in the next
section (3.9), enter a “2” for Digit 6 in programming section 3.9. This will
program the phone to automatically dial the number 777-1313 after the
first auto-dial number receives two (2) unanswered rings.
3.9 Enter # 0 0 followed by a series of ten digits as selected from the
options on the next page. An entry must be made for each of the ten
digits, in order for the phone to operate properly. By entering a number of
0-9 for each of the ten digits, the phone is customized for the particular
installation.
EXAMPLE: Enter # 0 0 0 1 6 0 0 2 0 0 0 5. This will program the
phone as follows:
Digit 1- Always 0.
Digit 2- Incoming calls allowed.
Digit 3- 6 minute conversation automatic call disconnect.
Digit 4- Always 0.
Digit 5- Always 0.
Digit 6- ADA activated. If a second auto-dial number is programmed, it
will dial out upon two (2) unanswered rings of the first auto-dial
number.
Digit 7- Always 0.
Digit 8- Do not dial PBX access number.
Digit 9- Always 0.
Digit 10- 250 ms wink detect.