Service manual

ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
8
6.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
6.1 Using a 301-064 security tool (sold separately) loosen and remove the
security screws.
6.2 The security tool is for a standard 5/32" button head screw generally used
on the framework of the phone booths.
6.3 Separate the faceplate assembly from the weatherproof housing or
mounting by pulling the faceplate forward.
6.4 Run the inside station wire into the enclosure and terminate on the RJ1lC
terminal block inside.
6.5 The use of a gas tube station protector is recommended. The station
ground should not exceed 50 ohms.
6.6 Plug the modular line cord from the faceplate assembly into the RJ11C
terminal block.
6.7 If you have not programmed the numbers then they should be entered
now. See section 3.0.
6.8 Dress the line cable away from the security screws and seat the faceplate
into the weatherproof housing or mounting.
6.9 Secure the cover assembly by tightening the security screws.
*****WARNING*****
A. Never install telephone wiring during a lightning storm.
B. Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
C. Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network interface.
D. Use caution when installing or modifying telephone lines.