Instructions / Assembly

on the decorative strip comes into contact with dust, oil, or grease of any kind it will not
adhere properly.
Dry-t all decorative strips before installation, and, if necessary,
trim them to the proper length. To dry-t, simply place the dot
end of the strip directly over the intersection of four ceiling tiles
and the length of the strip over the joint of two neighboring tiles.
If the strip is too long, simply cut it to size.
When you are ready to install, remove the peel surface protecting
the adhesive backing and press the decorative strip rmly into
place. Once again, make sure to line the dot end of the strip with
the intersection of four ceiling tiles and the length of the strip over the joint of two neighboring
ceiling tiles.
Butt the next decorative strip directly against the end of the rst,
creating a repeating pattern - the rst dot on the second strip
placed over the next four-way ceiling tile intersection. Again,
dry-t and trim as necessary.
If the decorative strip does not adhere for any reason, a small
amount of adhesive can be applied.
Important Note: Install all of the decorative strips running in one
direction rst and then nish by installing the strips perpendicular
to the rst set, this time trimming the dot off of the end of the
strips to create visual symmetry.