User Manual

In many areas, the GO X will only nd a single band to boost. You can see this under

the Advanced tab: one of the GO X’s radios will say Boosting and the other will remain

Scanning. If that’s the case, there’s only a single band available for the GO X to amplify.

However, in some areas, your GO X may nd two bands. If that’s the case, you may be able

to optimize your data rates by manually testing different bands.

Here are the steps we recommend following:

1. Discover all available bands

There may actually be more than 2 bands available outdoors. The GO X will attempt to

boost the best two available, but sometimes data rates may be better on other bands. If you

manually disable the rst two bands that the GO X has selected, you can force the GO X to

scan and show you what other bands are available.

2. Test each band individually, then together

When your phone detects multiple bands, it will attempt to “carrier aggregate” and

connect on multiple bands simultaneously. Unfortunately, carrier aggregation isn’t perfect -

sometimes it works well, but in other cases, it can actually decrease your data rates.

To get the absolutely best data rates, you can try running speed tests with the GO X

amplifying each band individually, and then testing different combinations of bands.

How to disable and enable bands

You can disable and enable bands under the “Booster

Settings” dropdown in the settings tab of the Wave app.

Each time you enable or disable a band, the GO X will rescan

to nd signal. It can take a minute or two until the GO X nds

and starts boosting signal again.

After the GO X starts amplifying a new band, toggle on

airplane mode on your phone for a few moments, then turn

it off again. This will force your phone to connect to the newly

boosted band before you run a speed test.

Optional: Test Band Combinations