Quick Start Guide

ManualsBrandsCel-FiTM ManualsCell PhonesCEL-FI QUATRA 4000 Cellphone Signal Booster

WARNING: In order to comply with FCC/ISED

RF Exposure requirements, this device must be

installed to provide at least 20 cm separation from

the human body at all times.

ISED STATEMENT

BEFORE USE, meet all requirements set out in

CPC-2-1-05.

This device may operate in a xed location only, for

in-building use.

In order to comply with FCC/ISED RF Exposure

requirements, this device must be installed to

provide at least 20 cm separation from the human

body at all times.

[FRENCH: Afin de se conformer aux exigences

d’exposition RF FCC / ISED, cet appareil doit

être installé pour fournir au moins 20 cm de

séparation du corps humain en tout temps.]

The Manufacturer’s rated output power of this

equipment is for single carrier operation. For

situations when multiple carrier signals are

present, the rating would have to be reduced by

3.5 dB, especially where the output signal is re-

radiated and can cause interference to adjacent

band users. This power reduction is to be by

means of input power or gain reduction and not by

an attenuator at the output of the device.

[FRENCH: La puissance de sortie nominale

indiquée par le fabricant pour cet appareil concerne

son fonctionnement avec porteuse unique. Pour

des appareils avec porteuses multiples, on doit

réduire la valeur nominale de 3,5 dB, surtout si le

signal de sortie est retransmis et qu’il peut causer

du brouillage aux utilisateurs de bandes adjacentes.

Une telle réduction doit porter sur la puissance

d’entrée ou sur le gain, et ne doit pas se faire au

moyen d’un atténuateur raccordé à la sortie du

dispositif.]

This device contains licence-exempt transmitter(s)/

receiver(s) that comply with Innovation, Science and

Economic Development Canada’s licence-exempt

RSS(s). Operation is subject to the following two

conditions:

1. This device may not cause interference.

2. This device must accept any interference,

including interference that may cause

undesired operation of the device.

[FRENCH: L’émetteur/récepteur exempt de licence

contenu dans le présent appareil est conforme

aux CNR d’Innovation, Sciences et Développement

économique Canada applicables aux appareils radio

exempts de licence. L’exploitation est autorisée aux

deux conditions suivantes:

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter toutz brouillage

radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.]

Gain 100 dB

Bandwidth 75 Mhz

Input and Output

Impedances

50 ohm

Output

Power

Uplink 22 dBm // Band 5: 20 dBm

Downlink 16 dBm // Band 5: 13 dBm

Compliance Contact

In the event of regulatory compliance issue, please

contact Nextivity Inc. directly. Contact information

is available at www.nextivityinc.com.

Patents

This product is covered by Nextivity, Inc., US

patents and patents pending. Please refer to

cel-.com for details.

reserved. Reproduction or media conversion by

any means is protected by copyright and may only

occur with prior written permission of Nextivity.

If you need help, visit: www.cel-.com/support.

Bureau in Europe

Unit 6, Basepoint Business Centre

Rivermead Drive, Westlea

Swindon SN5 7EX

U.S. Headquarters: Nextivity Inc.

16550 West Bernardo Drive

Bldg. 5, Suite 550

San Diego, CA 92127, USA

+1 858.485.9442 tel

+1 858.485.9445 fax

www.cel-.com

Nextivity Singapore Pte. Ltd.

2 Changi Business Park Avenue 1

Level 2 – Suite 16,

486015 Singapore