User manual

Blade Adjustment
8.0
SHARP BLADES-BE VERY
CAREFUL.
Caution: for safety ensure that the
Safety Key and Battery are removed
from the Mower before adjusting the
blade.
To adjust the blade turn the 2 bolts on the blade
shield. The cylinder should almost touch the
blade, but do not over tighten it.
If the cylinder hits the blade it is too tight and
will damage the cutting edge; loosen the nuts.
To check for correct adjustment, insert a piece
of paper between the blade and the cutting
cylinder. When the cutting cylinder is turned by
hand the paper should be cut cleanly.
CAUTION: DO NOT TURN THE
WHEELS AS THE BLADES WILL
ALSO TURN.
Cutting Cylinder
Paper
Blade
Bolt Bolt
Caution: For safety ensure that the Safety Key
and Battery are removed from the Mower before
adjusting the height.
To ensure that the roller is aligned correctly, it is
recommended that the height is adjusted on a level
surface. It is also recommended that the Grass Collector
be removed as this will allow easier access to the Locking
Knobs.
1. Pull out the knobs on both sides of the roller.
2. Holding both knobs, raise or lower the mower to the
desired height.
3. Allow the knobs to spring into the holes, ensure they sit
fully into the hole, are at the same height and properly
secured.
Cutting Height
6.0
Lower
Raise
Locking
Knob
Pull out
This mower uses sealed Pb lead acid batteries, which like all batteries can be damaged if
they are over-discharged. The electronic circuit will warn of low battery level and then will
break the circuit before the battery is damaged, the battery should be recharged at this
point.
GREEN LED ON–Normal operation.
GREEN LED FLASHING–Over work protection, release trigger to reset. (see section 9.1)
RED LED FLASHING–Battery is getting low.
RED LED ON–Battery flat, please charge to prevent over discharge damage.
Battery Level Warning
7.0