User Manual

FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC Caution : Any changes or modifications to the equipment not expressly
approved by the party responsible for compliance could void your authority to
operate the equipment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC ID : YI5-R05F2REC
Information on test modes and additional testing requirements
a) The modular transmitter has been fully tested by the module grantee on the
required number of channels, modulation types and modes, it should not be
necessary for the host installer to re-test all the available transmitter modes
or settings. It is recommended that the host product manufacturer installing
the modular transmitter, perform some investigative measurements to
confirm that the resulting composite system does not exceed the spurious
emissions limits or band edge limits (e.g.,where a different antenna may be
causing additional emissions).
b) The testing should check for emissions that may occur due to the intermixing
of emissions with the other transmitter, digital circuitry, or due to physical
properties of the host product(enclosure). This investigation is especially
important when integrating multiple modular transmitters where the
certification is based on testing each of them in a stand-alone configuration.
It is important to note that host product manufactures should not assume
that because the modular transmitter is certified that they do not have any
responsibility for final product compliance.
c) If the investigation indicates a compliance concern the host product
manufacture is obligated to mitigate the issue. Host products using a
modular transmitter are subject to all the applicable individual technical
rules as well as to the general conditions of operation in Sections
15.5,15.15,and 15.29 to not cause interference. The operator of the host
product will be obligated to stop operating the device until the interference
has been corrected.