Specifications

2 Insert a Q–card Nº6 into the Q–card slot located on the front of the
console. Until the card is inserted, the right-hand LCD panel
displays a message to that effect:
If the Q–card is not the correct type, the display shows ‘Q–card too
small’. The card should be removed and replaced with the correct
type, i.e. Q–card Nº6.
If the Q–card has been used on another console that was not a
Navigator the message ‘Wrong Data Format’ is displayed. In such
cases it is possible to write to the Q–card — which overwrites any
data on it — but not to read from it.
3 Once the Q–card is correctly inserted and functioning correctly any
error messages clear.
Note If the Q–card has not been used before, the display shows ‘No data
in Q–card’, and it is, therefore, only possible to write to the card.
To write data from the console to the Q–card press the [Write] soft
button. To read data from the Q–card to the console press the
[Read] soft button.
4 Before the read or write takes place, a prompt is displayed to
confirm the operation. This is achieved by pressing the two lower
soft buttons simultaneously.
Q–cards
EPD01003 Issue 3 (30/06/94) 91