Specifications

CAUTION
When reading or writing to a Q–card data can be lost if the
card and/or power is removed before the operation is
complete.
During the operation a ‘Read’ or ‘Write’ message is displayed on
the screen, which is cleared once complete; this takes
approximately six seconds.
5 Remove the Q–card and store in a safe place.
13.3
Titling a Q–card
Each Q–card can be electronically titled with a name of up to 16
characters.
To title a Q–card, proceed as follows:
1 Insert the Q–card.
2 Move to the “[STORE]” menu, then press the Next button to
display the “Q–card” menu.
3 Press the [Title] soft button to display the “Title Q–Card” menu.
4 By turning the Master Select the character at the cursor’s position
changes through the available characters (punctuation, A to Z, etc).
5 When the required character is displayed, pressing the [<] or [>]
soft buttons moves the cursor to the right or left, respectively.
6 When the required name has been entered using the above steps,
the Exit button should be pressed.
Navigator Operators Manual
92 EPD01003 Issue 3 (30/06/94)