Specifications

15.14 Cue Fader
See also Cues; Sequences; Preset Focuses; Cue Scroll; Cue Flash button.
The Cue Faders are located on the lower-half of the console, and
recall predefined lighting scenes, i.e. Cues and Preset Focuses.
Moreover, the Cue Faders are also used to replay Sequences.
– As the Cue Fader moves from the zero position to full any
HTP channels stored on the Cue fade proportionally to the
levels that are programmed.
– As the Cue Fader is moved past the trigger point (20%) the
LTP channels stored on the Cue will be set.
Refer to Section 6.4.
15.15
Cue Flashbuttons
See also Cue Fader.
Each Cue Fader has a Cue Flash button associated with it. Pressing
this button causes the Cue on the Cue Fader to be set
instantaneously to full; when the button is released the level of the
Cue returns to its previous setting.
Refer to Section 6.4.1.
15.16
Cue Scroll
See also Cue Block; “[SETUP] [DEFAULTS]” menu.
This Rotary Control selects which Cues are controlled by the Cue
Faders. The number of the Cue controlled by the left-most Cue
Fader is displayed on the last line of the left-hand LCD panel, with
the other Cue Faders controlling sequentially numbered Cues from
this setting.
Refer to Section 6.1.1.
Navigator Operators Manual
104 EPD01003 Issue 3 (30/06/94)