Specifications

5.7 Copy
The Copy function works in a similar way to the Gang function.
However, instead of linking channels together, it is used to copy the
current settingsfrom one channel or group of channelsto another.
Note Unlike Gang, after the Copy, any changes made to one channel do
not effect the others.
To use the Copy facility, proceed as follows:
1 Ensure the Channel Block setting is configured appropriately for
the devices. Refer to section 5.1.1.
2 Use Channel Scroll to bring the first set of channels that are to be
Copied onto the Rotary Presets.
Note The device that is being copied from must be in the left-most
position on the Rotary Presets.
3 The channels to be ‘copied’ from the device should be selected. For
LTP channels the corresponding Select buttons should be pressed;
this is indicated by the LED in the Select buttons illuminating. For
HTP channels it is any such channel with a non-zero level; this is
indicated by the LED in the Flash buttons illuminating.
Note There is no restriction on the number of channels in a Scroll Block
that can copied, i.e. from one to all.
4 Move to the “Store Options” menu.
5 Press the [Copy] soft button. Copy mode is then enabled.
6 Use the Channel Scroll to bring the next blocks of channels that are
to be copied onto the Rotary Presets, and press the [To] soft button.
Note The device that is being copied to must be in the left-most position
on the Rotary Presets.
Navigator Operators Manual
32 EPD01003 Issue 3 (30/06/94)