Specifications

Cue Blocksize
When using Cue Scroll the ‘window’ position changes in units that
can be set from 1 to 12. This is referred to as the Cue Block Size.
To change the Cue Block Size, proceed as follows:
1 Move to the “[SETUP] [DEFAULTS]” menu.
2 Use the [>] and [<] soft buttons to move the cursor to theCue Block
field and rotate the Master Select rotary clockwise or
anti-clockwise to increment or decrement the value as required.
6.2
Programming a Cue
The Navigator console can control channels in both LTP and HTP
modes, and a single Cue can control both types of channel,
provided the channel operating modes are defined before the Cue
is stored — refer to section 5.2.2.
6.2.1 Previewing a Cue
The process of previewing a Cue allows the current settings for a
Cue to be viewed, and modified if necessary. This process is
achieved by using the Cue Scroll rotary to bring the desired Cue
into view, and then pulling-back the Cue Fader past the 0% position
and holding it there.
Whilst the Cue Fader is held-back, and hence the Cue previewed,
the left- and right-hand LCD panels display status information
about the Cue:
Cue programming
EPD01003 Issue 3 (30/06/94) 37