Specifications

6.2.2 Storing a Cue
Cues can be stored in either Live or Blind mode, but the technique
is slightly different for each.
Live
In Live mode, i.e. with the Preset Master up, proceed as follows:
1 Ensure that all channels to be part of the Cue have been configured
for HTP or LTP mode as required. Refer to section 5.2.2.
2 Ensure the Grand Master is at full.
3 Set the required channels to the desired levels using the Rotary
Preset controls, using the Channel Scroll if necessary to scroll the
channels into view. For any channels that are active, i.e. above
zero, the LED in their Flash button is illuminated.
4 Use the Cue Scroll control to bring the Cue to store into range.
Preview the Cue by pulling-back and holding the appropriate Cue
Fader, then press the Enter button to store the Cue. During the
time that the Cue is being stored the LED in the Enter button is
illuminated; this process takes approximately one second.
5 Release the Cue Fader.
Note Once a Cue has been stored and the Cue Fader released the scene
remains in memory until it is either cleared, overwritten, or
modified in some manner.
Blind
In Blind mode, i.e. with the Preset Master down, proceed as
follows:
1 Ensure that all channels to be part of the Cue have been configured
for HTP or LTP mode as required. Refer to section 5.2.2.
2 Ensure the Grand Master is at full.
3 Move to the “Store Options” menu; this allows the value of the
channels to be viewed as they are modified.
Navigator Operators Manual
38 EPD01003 Issue 3 (30/06/94)