Specifications

To configure a timed Cue, perform the following steps:
1 Ensure the fade facility is enabled at the “Set Defaults” menu. To
change this setting, proceed as follows:
i Move to the “[SETUP] [DEFAULTS]” menu.
ii Press the [>] and [<] soft buttons to move the cursor to the
Fade field, and rotate the Master Select to change the setting
to ‘on’.
iii Press the Exit button.
2 Use the Cue Scroll control to bring the Cue to modify into range.
Preview the Cue by pulling-back and holding the appropriate Cue
Fader. Information about the Cue is displayed on the LCD panels.
3 Press the [>] and [<] soft buttons to move the cursor to theTime
field, and rotate the Master Select clockwise or anti-clockwise to
increment or decrement the value to 0 seconds or from 0.3 to 60
seconds in the following steps:
– 0.3 second steps between 0.3 and 2 seconds.
– 0.2 second steps between 2 and 5 seconds.
– 0.5 second steps between 5 and 10 seconds.
– 1.0 second steps between 10 and 60 seconds.
4 Release the Cue Fader to set the changes.
6.3.2 Editing a Cue
Once a Cue has been programmed it can be edited in either:
– Live mode, where the output from the console changes
immediately as the modifications are performed.
– Blind mode, where the modifications are not reflected in
console output as the modifications are performed.
Navigator Operators Manual
40 EPD01003 Issue 3 (30/06/94)