Specifications

Live mode
To modify a Cue in live mode, i.e. with the Preset Master up,
proceed as follows:
1 Ensure that all the Cue Faders are down, and no channels are
selected by pressing the Clear button.
2 Use the Cue Scroll control to bring the Cue to modify into range
then replay it by moving the Cue Fader to full.
3 Press the Mod button, which is located at the far right-hand side of
the console.
Note All the HTP/LTP channels associated with the Cue are
automatically selected, indicated by the LEDs in their Flash/Select
buttons illuminating.
4 For channels operating in LTP mode the Rotary Controls are used
to modify the levels, which are reflected immediately on the
console’s output. To remove any unwanted LTP channels from the
Cue, simply press the corresponding Select button; it’s LED is
extinguished. Similarly, to add any channels to the Cue, press the
corresponding Select button; it’s LED is illuminated. The rotary
Control is then use to set the desired level for the channel.
5 For channels operating in HTP mode the Rotary Controls are,
again, used to modify the levels which are reflected immediately
on the console’s output. HTP channels are automatically included
in the Cue when their level is on (non-zero) and excluded when off
(zero). If included the LED in the corresponding Flash button is
illuminated.
6 To confirm the changes made, Enter should be pressed; to
abandon any changes Mod should be pressed.
Note There is no ‘undo’ facility. To cancel any changes made, the only
way to achieve this is to repeat the above process and manually
reset the levels to their previous values.
Cue programming
EPD01003 Issue 3 (30/06/94) 41