Specifications

Blind mode
To modify a Cue in Blind mode, i.e. with the Preset Master down,
proceed as follows:
1 Ensure that all the Cue Faders are down.
2 Use the Cue Scroll control to bring the Cue to modify into range
then preview the required Cue by pulling-back the appropriate
Cue Fader and holding it there.
3 Press the Mod button, which is located at the far right-hand side of
the console.
Note All the HTP/LTP channels associated with the Cue are
automatically selected, indicated by the LEDs in their Flash/Select
buttons illuminating.
4 For channels operating in LTP mode the Rotary Controls are used
to modify the levels, which are displayed on the right-hand LCD
panel:
To remove any unwanted LTP channels from the Cue, simply
press the corresponding Select button; it’s LED is extinguished.
Similarly, to add any channels to the Cue, press the corresponding
Select button; it’s LED is illuminated. The Rotary Control is then
use to set the desired level for the channel.
5 For channels operating in HTP mode the Rotary Controls are,
again, used to modify the levels which are displayed on the
right-hand LCD panel. HTP channels are automatically included in
the Cue when their level is on (non-zero) and excluded when off
(zero).
6 To confirm the changes made, Enter should be pressed; to
abandon any changes Mod should be pressed.
Navigator Operators Manual
42 EPD01003 Issue 3 (30/06/94)