Specifications

2 Press the Next button twice to display the “Cue Insert/Delete”
menu:
3 ToinsertaCuepressthe[Insert] soft button. A new Cue is
inserted after the current position, and all Cues after this position
are moved up by one, e.g. if a Cue was inserted at Cue #55, then
Cue #56 is now Cue #57, Cue #57 is now Cue #58, etc.
To delete a Cue press the [Delete] soft button. All Cues after the
current Cue position are moved down by one, e.g. if a Cue was
deleted at Cue #55, then Cue #56 is now Cue #55, Cue #57 is now
Cue #56, etc.
4 If inserting a new Cue it is then edited using the procedure
described above.
Note When inserting a new Cue, the last Cue, i.e. Cue #239, is stored in a
temporary location. If a delete operation is performed immediately
after the insert operation then Cue #239 can be recovered;
otherwise it is permanently lost.
6.4
Replaying a Cue
To replay a Cue, proceed as follows:
1 Use the Cue Scroll control to bring the Cue into view on the Cue
Faders.
2 Move the Cue Fader corresponding to the Cue up.
– As the Cue Fader moves from the zero position to full any
HTP channels stored on the Cue fade proportionally to the
levels that are programmed.
– As the Cue Fader is moved past the trigger point (20%) the
LTP channels stored on the Cue will be set.
Note Once LTP channels have been triggered they remain as set until
another Cue or Sequence changes them.
Navigator Operators Manual
44 EPD01003 Issue 3 (30/06/94)