Specifications

7.2.1 Storing a PresetFocus
To store a new Preset Focus, proceed as follows:
1 Ensure that all channels to be part of the Preset Focus have been
configured to LTP. Refer to section 5.2.2.
2 Ensure the Grand Master is up; the Preset Master is up; and all Cue
Faders are down.
3 Move to the “[STORE] [FOCUS]” menu.
Note The Cue Scroll and Cue Faders now control Focuses instead of
Cues and are therefore referred to as Focus Scroll and Focus Faders
respectively.
4 Set the required channels to desired levels using the Rotary Preset
controls, using the Channel Scroll if necessary to scroll the
channels into view. For any channels that are active, i.e. on, the
LED in their Flash button is illuminated.
Note Only LTP channels can be incorporated into Preset Focuses.
5 Use the Focus Scroll — labelled Cue Scroll — rotary to bring the
Focus to store into range. Preview the Focus by pulling-back and
holding the appropriate Focus Fader, then press the Enter button.
During the time that the Focus is being stored the LED in the Enter
button is illuminated; this process takes approximately one second.
6 Release the Focus Fader.
Note Once a Focus has been stored it remains in memory until it is
either cleared, overwritten, or modified in some manner.
Navigator Operators Manual
50 EPD01003 Issue 3 (30/06/94)