Specifications

7.4 Assigning PresetFocuses
Once a Preset Focus has been defined, using the procedure
described above, it needs to be assigned to a Cue before it to can be
played back.
– A Cue can have up to six Focuses assigned to it.
– Any Focus can be assigned to any Cue.
– A Focus can be assigned to more than one Cue.
To assign a Focus to a Cue, proceed as follows:
1 Use the Cue Scroll rotary to move the Cue into view and preview
the Cue by pulling-back the appropriate Cue Fader and holding it
there. Information about the Cue is displayed on the left- and
right-hand LCD panels.
2 Press the [>] button to move the cursor to the start of the Focuses
field, which comprises six entries.
Note The cursor is initially on the right-hand LCD panel, and the [>] soft
button needs to be pressed four times to move to the field, which is
located on the left-hand LCD panel.
3 Use the Master Select to increment or decrement the number until
the required Focus number is reached.
4 Use the [>] and [<] soft buttons to move the cursor the other
entries in the Focuses: field and set their values as required.
Note To remove, or unassign, a Focus, set the Focus number to zero.
5 Release the Cue Fader.
Navigator Operators Manual
52 EPD01003 Issue 3 (30/06/94)