Specifications

4 Use the Rotary Controls to change the level of any HTP channels
as required. The LED in the Flash button illuminates
proportionally.
5 Select any LTP channels required in the first Sequence step by
pressing the appropriate Select buttons and then set the required
level with the Rotary Controls.
6 When all the appropriate intensity levels, positions, and colours,
have been set, press the [Step] soft button. The settings are then
recorded as the first step, and the step number on the display
increments.
7 Repeat steps 4 to 6 to record further steps, up to a maximum of 16
steps.
Hint After storing a step, if the current HTP and LTP channels are not
included in the next step, press the Clear buttontodeselectthem;
otherwise, simply change the levels and positions of them as
required.
8 After recording the steps, press the [End] button after the last step
has been entered.
Note If a Sequence contains 16 steps, there is no need to press the [End]
button, as the step number automatically returns to 1 after step 16
has been entered.
8.2.1 Sequence parameters
Each Sequence also contains a number of additional parameters:
– Sequence speed.
– Loop and Stop.
– Snap and Fade.
Cue Sequence programming
EPD01003 Issue 3 (30/06/94) 57