Specifications

To change any of these parameters, proceed as follows:
1 Use the [>] and [<] soft buttons to move the cursor over the
parameter.
2 Rotate the Master Select clockwise or anti-clockwise to increment
or decrement the value as required.
Sequence speed
This parameter determines the time interval between each
Sequence Step, and is expressed in beats per minute (BPM). Refer
to section D.3.2 for details of available values.
Hint It may be better to set the Sequence speed when the Sequence has
been assigned as it is then possible to view the effect of the
Sequence live.
Loop and Stop
This parameter determines how a Sequence is replayed.
– When ‘Loop’ is selected, the Sequence continuously runs each
pass.
– When ‘Stop’ is selected, the Sequence runs for one pass only,
then stops on the last step.
Snap and Fade
Note This section only applies to channels operating in LTP mode.
When a Sequence plays from one step to another, the LTP values
can change in one of two ways:
– If ‘Snap’ is selected, the output levels change instantaneously
to the new levels when the Sequence moves between steps.
Navigator Operators Manual
58 EPD01003 Issue 3 (30/06/94)