Specifications

However, when a channel is being controlled by more than one
Sequence:
– If the channel is operating in HTP mode, the level will be the
highest value set by any of the Sequences.
– If the channel is operating in LTP mode, the level will be that
specified by the last Sequence to effect it.
Current Controlled Sequence
When running multiple Sequences only one of these can be
displayed, and hence stored or modified, at a time. This is referred
to as the Current Controlled Sequence, and is set automatically
depending upon the current operating mode.
Live mode
When operating in live mode, as determined by the Preset Master,
the Current Controlled Sequence is:
– When all the Cue Faders are down, it is Sequence Pattern #1.
– When a Cue Fader is up, it is the Sequence Pattern assigned to
that Cue Fader.
– When more that one Cue Fader is up, it is the Sequence Pattern
assigned to the first Cue Fader from the left (as determined by
Cue Scroll).
Blind mode
When operating in Blind mode, as determined by the Preset
Master, the Current Controlled Sequence is:
– Sequence Pattern #1 irrespective of the position of the Cue
Faders.
Manual setting
Note When storing a Sequence for the first time, the following steps can
be performed to manually set the Current Controlled Sequence
number, which overrides the automatic setting:
1 Move to the “[STORE] [SEQUENCE]” menu.
Navigator Operators Manual
64 EPD01003 Issue 3 (30/06/94)