Specifications

Note The Sound-to-Cue will also effect any Sequence or Preset Focus on
the Cue Faders.
11.4
Bass step control
The bass component of the sound source can also ‘drive’ a
Sequence through its steps. The Sequence is stepped when a change
in the bass component is detected.
To set a Sequence to use the Bass step control, proceed as follows:
1 Set the current Controlled Sequence to the Sequence to be
controlled by the Bass step. Refer to section 8.5.2.
2 Press the Bass button; the LED in the button illuminates to indicate
Bass step is enabled. Pressing the Bass button again disables bass
step; the LED is extinguished.
The Sound-to-Light system
EPD01003 Issue 3 (30/06/94) 81