Specifications

3 The Sequence is then stepped when the level of the bass signal
changes.
Note If the Sequence selected has a BPM setting, the Sequence will also
step at the time interval determined by this setting. This can be
stopped by pressing the Stop button; the LED in the button
illuminates.
11.5
Sound-to-Light problems
If the Sound to Light system is active – causing Cue Faders #1, #2
and #3 to rise above zero – some flickering will be seen on the Cue
Flash buttons. This is because the Sound-to-Light system overrides
the level set on the Cue Fader on a Highest Takes Precedence
(HTP) basis. Therefore, if Cue Fader #1 is previewed and some
Bass notes are played, the level of the Cue Fader will rise
momentarily, causing the Cue to move out of preview.
The level will alternate in time with the beat, between the value set
by the Sound-to-Light and that of the physical Fader. This will
cause the display to flash in time to the music.
Navigator Operators Manual
82 EPD01003 Issue 3 (30/06/94)