Specifications

To program a new Soft Patch, proceed as follows:
1 Move to the “[DIM PATCH]” menu.
2 This menu displays a number of items:
– Dim, showing the number of the Dimmer Channel.
– Chan, showing the number of the Console Channel that it is
patched to.
– @, proportional level.
To changes the values of these items use the [>] and [<] soft
buttons to move the cursor to the required field, and rotate the
Master Select to increment or decrement the value accordingly.
3 Set the Dim field to the number of the Dimmer Channel required.
4 Set the Chan field to the Console Channel that it should be patched
to.
5 Move the cursor next to the @ symbol and set the proportional
level for the Patch. This setting is expressed either on a scale of
0–255 or 0–100 (i.e. percentage), as determined by the “[SETUP]
[DEFAULTS]” menu.
6 Repeat steps 3 to 5 for all the Dimmer Channels required.
12.4
Modifying a Patch
To check what Console Channels are patched to what Dimmer
Channels, and to remove their patching if required, proceed as
follows:
1 Move to the “[DIM PATCH]” menu.
Navigator Operators Manual
86 EPD01003 Issue 3 (30/06/94)