User guide

28
Positioning a Lamp
 Firstly, ensure that the Lamps that you wish to position are
selected and in Controlled Mode.
Any Lamps, which are in Included Mode or deselected will not be
affected by any Position changes.
To apply a Pre-defined Position...
A dimly lit LED will show the presence of any pre-defined positions for the
selected Lamp(s) on the Position buttons
 To apply one of these Position options, press the appropriate
button; the button LED will light fully to show that it is active.
If a specific position value had previously been applied to the
Lamp(s), applying a pre-defined option will overwrite that value.
IMPORTANT NOTE
Remember that the pre- defined positions can be different for each
Lamp (included focus channel).
To apply a specific Position...
 If required, choose an existing Position option to start from.
 Select absolute or relative mode using the abs/rel button.
 Set the pan and tilt wheels to modify the position to suit your
requirements.
 Set the focus attribute if available to sharpen or soften the edge
on that particularly position.
To save a Specific Position as a Pre-defined Option...
 Set- up the new Position as described previously (‘To apply a
Specific Position’).
 Decide which Position button you wish to define with the new
setting, then hold down the button.
If a particular button has already been defined, its button LED will
be lit dimly. Storing to one of these buttons will overwrite the
previous settings.
 Whilst holding down the Position button, press the save lamps
button; the current Position setting will now be stored as that
option.
HELPFUL HINT
You can also set- up, view or modify Positions using the Position Entity
Screen (see page 84).
Setting Lamp Intensity
 Firstly, ensure that the Lamps that you wish to set are selected
and in Controlled Mode.
Any Lamps, which are in Included Mode or deselected will not be
affected by any Intensity changes.
 Select absolute or relative mode using the abs/rel button.
 Use the intensity digital fader to modify the intensity of the
selected Lamps.
 To set all selected Lamps to maximum level, press the full button.
 To set all selected Lamps to zero level, press the off button.