User guide

Assigning Sequence(s) to a Cue

 Call- up Cue Entity Screen 2 on the Main LCD for the required Cue

(e.g. press cue 1 next next in the Main Keypad Control Area).

Cue:1 Assign Seq1:1 @100 Seq 1

Assign Seq2:2 @100 Seq 2

Assign Seq3:--- @--- -----

Details of: [1] [2] [3]

 Move the cursor to one of the Assign Seq fields and select the

required Sequence number. The name of the chosen Sequence

will appear on the right- hand side of the display, as in the example

above.

 By default, the replay level of the Sequence will be set to 100%.

To change this, move the cursor to the value following the @

symbol and adjust it to the required level.

 To check or modify the replay parameters for a Sequence, press

the corresponding soft function button. The Sequence Control

Screen will appear:

Cue:1 Assign:1 Seq:1 @100 Seq 1

Dir:Fwd Order:Linear Autosel:Off

Times HTP:Snap LTP:Fade At End:Loop

BPM:60 STL:None AF:Time Part 1

The top line of this screen repeats the information shown on Cue

Enity Screen 2. These fields cannot be altered using the Sequence

Control Screen.

 For further guidance on setting-up Sequence replay parameters,

refer to the Section on Sequences (page 60 onwards).