Instructions / Assembly

x6 Glass Panels

x4 Linear Connectors

x4 Corner Connectors

with foot

x4 Cylinder foot

Parts Included:

x4 Corner Connectors

Tools Needed:

Phillips Head

Screwdriver

1. Begin by connecting two glass

panels using a linear connector.

Make sure the “Caution-Hot” sign

is on at least one of the panels,

and facing out. Repeat with other

set of panels.

To Ensure Quality Assembly:

• Lay out parts on at surface, grouped together

by type of part

• Make sure plastic safety backing remains in

place on all screws to prevent cracking or shattering

the glass

2. Connect the pairs of glass

panels at the bottom using the

other two linear connectors.

Two cylinder feet can be applied

about 1 inch away from each

side of the bottom linear connector.

3. Using one pair at a time of the

connected glass panels, connect a

single glass panel at either end using

corner connectors. Make sure that

the bottom connector (with foot) is on

the bottom, and the corner connector

without foot is on top. The other pair of

panels can be connected to the single

glass panel on its other edge with the

other corner connectors.

4. Once you have done the

same to the other side, go

around to all of the connec-

tors and make sure that the

screws are holding the glass

panels tightly in place.

PAGE 1
• • To Ensure Quality Assembly: Lay out parts on flat surface, grouped together by type of part Make sure plastic safety backing remains in place on all screws to prevent cracking or shattering the glass Parts Included: x6 Glass Panels x4 Linear Connectors x4 Corner Connectors 1. Begin by connecting two glass panels using a linear connector. Make sure the “Caution-Hot” sign is on at least one of the panels, and facing out. Repeat with other set of panels. 3.
PAGE 2
• • To Ensure Quality Assembly: Lay out parts on flat surface, grouped together by type of part Make sure plastic safety backing remains in place on all screws to prevent cracking or shattering the glass Parts Included: x4 Glass Panels x4 Linear Connectors x4 Linear Connectors with feet 1. Begin working from the bottom up by connecting two upside down glass panels using a linear connector with foot. Make sure the “Caution-Hot” sign is on at least one of the panels, and facing out.